5A 12V Overcurrent Protection AC Current Detection Sensor Module
5A 12V Overcurrent Protection AC Current Detection Sensor Module LC 5A 12V Overcurrent Protection AC Current Detection Sensor Module uses a current transformer to collect the AC signal to achieve the relay over-current signal output within 0-5A. Relay pull while over-current, relay released while not over-current. Users can use the relay COM; NC, NO three ports to control the external circuit on and off, in order to achieve over-current protection. This product is known as 5A Overcurrent Protection Sensor Module AC Current Sensor 12V Relay, 5A 12V AC over-current protection sensor module, 5A Overcurrent Protection Sensor Module AC Current Detection Sensor, 5A 12V Overcurrent Protection AC Current Detection Sensor Module
- Current detection resolution can change the parameter of resistance parameters
- Output over-current switching signal output
- The over-current signal setting critical point adjustable
- By setting the potentiometer to set the overcurrent protection point, the clockwise adjustment reduces the detection current.
- Measured the wire through the current transformer, connect VCC and GND to the DC12V power supply
- Adjust the potentiometer, when you hear the sound of the relay pull (can be measured with a multimeter COM and NO whether was turned on; is connected to the relay means activated), then reduce or cut off the current flowing that through the tested wire; if the relay release at this time that over-current protection point has been identified (available to multimeter COM and NC measurement whether is connected; is connected to the relay means it release).
- When reducing or cut off the current flowing through the wire; the relay is not released, will still need to continue to adjust the potentiometer to find the over-current protection point.
This product is known as 5A Sensor Range of Single-Phase Module, 5A Sensor Range of Single-Phase Module Ac Current Sensor Module, Current transformer module 5A range single-phase AC current sensor module.
- Operating voltage: 12VDC
- Operating current: <20MA
- Operating frequency range: 20Hz ~ 400Hz
- Output Mode: Switch signal output
- Maximum detection wire diameter: 5.2mm
- Mounting Hole: Hole Diameter is 3mm, Hole distance: 52.5mm
- Operating Temperature: -40°C ~ +85°C
- The Current Detection Range: 0.3A ~ 5A
- Relay load: AC 250V maximum current, DC 30V 10A maximum current
- Length: 38 mm
- Width: 44 mm
- Height: 12 mm
- Weight: 22 gm
- 1 x 5A 12V Overcurrent Protection AC Current Detection Sensor Module
Note: Product Images are shown for illustrative purposes only and may differ from the actual product.