M2.5X6 mm Brass Heat Set Threaded Round Insert Nut
M2.5X6 mm Brass Heat-Set Threaded Round Insert Nut. The Brass Heat-Set Threaded Round Insert Nuts is used every day for assemblies and components that need to be joined together. When fasteners are used in traditional manufacturing, bolts are often tapped straight into the metal substrates. 3D printed parts are unique from a material and robustness standpoint, therefore threaded holes can wear easily if the fasteners are taken on and off multiple times. Heat-set threaded inserts are your method for success for these types of assemblies. The Heat-Set Threaded Round Insert Nut has been designed for post-mold installation into notch-sensitive thermoplastics using heat. It features very high pull-out and torque resistance. A heat-set threaded insert has two important features. The inside of the brass piece of hardware has a nice, threaded thru the hole. The exterior has knurls and ridges, so when installed using heat, the plastic can easily flow around and then solidify. Once solidified, the insert is in place, making it resist torque and pull-out. Tags, M2x6 Brass insert nut, M2.5 Round Metal Knurl Thread Insert Nuts, M2.5 Round Nuts, M2.5x6mm Female Threaded Brass Knurled Insert Nut. M 2.5x6mm, M 2.5 x 5 mm, M2.5x6mm.
Note: Product Image and color may vary slightly from the actual product.
Tools you need:
- Heat-set threaded Insert Nut
- Plastic Body Part
- Soldering Iron
Preparing the threaded insert:
Use the soldering iron on a low setting to preheat the threaded insert using a shallow tapered soldering iron tip.
When the threaded insert is up to temperature (should only take a few seconds) apply the insert to the appropriate hold. Apply a very little amount of pressure and the insert will melt the plastic in the hole and allow the insert to be set in place. The plastic will flow around the knurls of the insert. Be sure to align the insert squarely and flush it to the plastic surface. Remove the soldering iron when it is in place.
After a few moments, the threaded insert will be ‘set’ within the plastic. The threaded insert is ready to receive the screw’s threads and the parts can be assembled.
- Material: Brass
- Thread Size: M2.5
- Flow-Sert is a blind insert for installation during the molding process
- Brass Material Can Resist Heat.
- Not Easy to Rust, Strong Corrosion Resistance.
- Very high pull-out and torque resistance.
- Color: Golden
- Thread Pitch: 0.5 mm
- Internal Diameter(ID): 2.5 mm
- Outer Diameter (OD): 3.8 mm
- Length of Nut: 6 mm
- Approx Weight: 0.12 gm
- 1 x M2.5X6 mm Brass Heat Set Threaded Round Insert Nut
Note: Product Images are shown for illustrative purposes only and may differ from the actual product.
There are no reviews yet.