Search Results for: TTL TO RS
M3X6 mm Brass Heat Set Threaded Round Insert Nut
M4X6 mm Brass Heat Set Threaded Round Insert Nut
M5X4 mm Brass Heat Set Threaded Round Insert Nut
M4X8 mm Brass Heat Set Threaded Round Insert Nut
M3X4 mm Brass Heat Set Threaded Round Insert Nut
QC962-8A Mornsun Hybrid Integrated IGBT Driver Module
74HC109 Dual J-K Positive-Edge-Triggered Flip-Flop IC – DIP-16 Package
XH-M240 Battery Capacity and Discharge Energy Testing Meter For 18650 Lithium-Ion Battery
ZB2L3 18650 Li-ion Lithium Battery Capacity Tester
L9110S Motor Control Driver IC – SOP-8 Package
- 800mA continuous current output capability per channel
- Lower saturation voltage
- TTL / CMOS output level compatible, and can be directly connected to the CPU
- Output built-in clamp diodes for inductive load
- Integrated control and drive into a monolithic IC
- With pin high-voltage protection function
- Operating temperature: 0 ℃ -80 ℃
9V Battery Operated LCR-T4 12864 LCD Graphical Transistor Tester Resistance Capacitance ESR SCR Meter
TDS-3 Water Quality Tester Range 0-9990ppm Without Battery
74HC14 Hex Inverting Schmitt Trigger IC DIP-14 Package
PN532 NFC RFID Read And Write Module V3 Kit
- PN532 NFC RFID Read And Write Module
- Module Size: 42.7mm x 40.4mm x 4mm
- Easy to change mode: with a small SMD toggle Switch, it becomes very easy to change among IIC, SPI, and HSU modes
- Longer distance: the reading distance becomes 5~7cm, compared with 4~6 cm of the last version
- Built-in PCB Antenna, with 5cm~7cm communication distance
- On-board level shifter, Standard 5V TTL for I2C and UART, 3.3V TTL SPI
- Work as RFID reader/writer
- Work as 1443-A card or a virtual card
SeeedStudio Seeeduino Xiao Arduino Microcontroller SAMD21 Cortex M0+
LM2596S-5.0 – 5V 3A 150kHz Step-Down Switching Regulator HTC– TO-263-5 Package
DW01A Lithium Battery Protection IC – SOT23-6
- Part Number: DW01A
- Ultra-Low Quiescent Current at 3 µA (Vcc =3.6V)
- Over-discharge Current at 4 µA (Vcc = 1.8V)
- Precision Overcharge Protection Voltage 4.3 V ± 50 mV
- Overcharge Detection Voltage: 4.3V
- Overcharge Release Voltage: 4.1V
- Over-discharge Detection Voltage: 2.4V
- Over-discharge Release Voltage: 3.0V
UDN2981A 8-Channel Source Driver IC-Package 18-Dip
LM555CN Timer IC – 8-DIP
CH-813 0.08-2.5mm SPL- 3 Pole Wire Connector with Spring Lock Lever for 3 Wire line Connection
CH-812 0.08-2.5mm SPL-2 Pole Wire Connector with Spring Lock Lever for 2 Wire line Connection
GY-9960-3.3V APDS-9960 RGB Infrared Gesture Sensor Motion Direction Recognition Module
12VDC Switch Delay Relay Module with Adjustable Delay Time 0~25 Second Signal Triggering Switch Module
DIY D2-1 Intelligent Line Follower/Tracing Car Kit
Flexible USB LED Light
Transparent ABS Plastic Case for Arduino UNO R3
18650 Battery Charging Aluminium Body
Mini Portable USB LED Book Light
LM2576-ADJ 3A Adjustable Switching Voltage Regulator SMD TO-263-5 Package
