ST-LINK/V2 in-Circuit Debugger/Programmer for STM8 and STM32
The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. Much similar in architecture for debugging, the ST-LINK/V2 and the ST-LINK/V2-ISOL share the same features like digital isolation between the PC and the target application board which allows to withstands voltages of up to 1000 Vrms. Specifically, the debugger incorporates the use of a USB full-speed interface to communicate with the ST Visual Develop (STVD)  or ST Visual Program (STVP) software for the STM8 application, and the use of the USB full-speed interface to communicate with Atollic®, IAR™, Keil®.
Note: Not recommended for Industrial Use.
Supported Products:
- STM8 (A, L and S)
- STM32 (F, L and W)
Features/Specs:
- Input Supply voltage: 1.65 – 5.5V
- USB type: USB A to Mini- B cable
- 5V power supplied by a USB connector
- USB 2.0 full speed compatible interface
- USB standard A to mini B cable
- 1.65V to 5.5V application voltage supported on SWIM interface
- SWIM low speed and high-speed modes supported
- 1.65V to 3.6V application voltage supported on the JTAG/SWD interface and 5V tolerant inputs
- Direct firmware update feature supported
- Status LED which blinks during communication with the PC
Datasheet: ST-LINKV2 in-circuit debugger programmer for STM8 and STM32
Useful links: Video
Package Includes:
- 1 x ST-LINK/V2 debugging and programming Unit
- 1 x USB standard A to mini B cable
- 1 x Connecting Cable for STM8 SWIM and STM32 JTAG/SWD protocol
- 1 x Flat ribbon with a standard ERNI connector at one end (A JTAG or SWD and SWV flat ribbon with a 20 pin connector)
Note: Product Images are shown for illustrative purposes only and may differ from the actual product.
Reviews
There are no reviews yet.