L298N 4 CHANNEL DC MOTOR DRIVER
This module has the characteristics of small size and convenient control. Adopting this module will make your motor control freely, and it can cope with the problems that require high power stepper motors. This module can control two-phase, three-phase, and four-phase motors. Supports 2-way DC motor drive control and 4-phase stepper motor control.
- Low level: -0.3V≤Vin≤1.5V
- High level: 2.3V≤Vin≤Vss
- Low level: -0.3≤Vin≤1.5V (the control signal is invalid)
- High level: 2.3V≤Vin≤Vss (control signal is valid)
- Driver Chip: L298N dual H-bridge DC motor driver chip
- Power Supply of Driving Terminal: + 5V~+ 30V (the range is + 6V~+30V
- Operating Current of Logical Part: 0 ~ 36mA
- This drive module integrates the two L298N chip, it can drive four DC motors (reversible, can use PWM to control speed) or two stepper motors.
- It integrates LM2596 DC-DC voltage regulator chip (which can output 5V, can power for the SCM, servos, sensor, router. the battery can up to 2A).
- In addition to the two pieces L298N chip on the board, and then integrate a ULN2003 can drive one more stepper motor, or four DC motors (start and stop, not reversible). For example, when making a fire-fighting robot, it can control the extinguishing fans, not need an external circuit.
- Integrated servo interface, leads to the signal terminal, it’s convenient to dock with SCM.
- Integrated USB connector, which can be directly powered by plugging into the router.
- Apply to W703N, WIFI car router modification. inserting USB, leading out the RDX TXD through pins, it is convenient to communicate with its own SCM.
- 5V DC output leading-out terminal (terminal, pin), it’s convenient to power for the 5V external devices.
- Max Power Consumption: 20W (when the temperature T = 75 °c)
- Storage Temperature: -25 °c + 130 °c
- Length: 90mm
- Width: 54mm
- Height: 25mm
Datasheet: L298N 4 CHANNEL DC MOTOR DRIVER
Note: Product Images are shown for illustrative purposes only and may differ from actual product.