ENC28J60 Ethernet LAN Module

ENC28J60 Ethernet LAN Module

The ENC28J60 is a stand-alone Ethernet controller with an industry-standard Serial Peripheral Interface (SP). It is designed to serve as an Ethernet network interface for any controller equipped with SPI. The ENC28J60 meets all of the IEEE 802.3 specifications. It incorporates a number of packet filtering schemes to limit incoming packets. It also provides an internal DMA module for fast data throughput and hardware-assisted IP checksum calculations. Communication with the host controller is implemented via two interrupt pins and the SPI, with data rates of up to 10 Mb/s.

Features/Specs:

• Driver Chip: ENC28J60-I/SO
• Supply Voltage: 3.3V
• Crystal Oscillator: 25 MHz
• Ethernet Port: HanRun HR911105A
• Fully Compatible with 10/100/1000Base-T Networks
• Integrated MAC and 10Base-T PHY
• Supports One 10Base-T Port with Automatic Polarity Detection and Correction
• Supports Full and Half-Duplex modes
• Automatic Programmable Retransmit on Collision
• Programmable Padding and CRC Generation
•  Automatic Rejection of Erroneous Packets
• SPI Interface with Clock Speeds Up to 20 MHz
• Chipboard ENC28J60/SS
• The board 25MHZ crystal
• The network interface board HR911105A
• 3.3 V power supply pin
• Stable performance
• For Arduino, SPI, AVR, PIC, LPC, STM32

Package Includes:

• 1 x ENC28J60 Ethernet LAN Module

Note: Product Images are shown for illustrative purposes only and may differ from the actual products.