100k NTC Thermistor Probe With 2 Pin JST Connector – 1 Meter Cable
This is a High-Temperature NTC 100K Thermistor with 1 Meter Cable for 3D Printer Reprap. The thermistor is a thermally sensitive resistor known for exhibiting a large change in resistance with only a small change in temperature. It is important to note that a thermistor’s change in resistance is non-linear. It follows a pre-defined curve which is provided by the thermistor manufacturer. Positive thermal coefficient (PTC) will increase in resistance with an increase in temperature, and negative ones (NTC) will decrease. But the formula in practice is not linear, so sometimes an accurate table of measurements is better than the linear formula. These measurements can usually be found in the datasheet that accompanies the thermistor. This Product is Known as 100K Ohm NTC, 100K Ohm NTC Thermistor, 100K Ohm Thermistor, 10K NTC, 100K Negative Temperature Coefficient Thermistor, 100K NTC Thermistor, or 100K Thermistor.
Features:
- Temperature range of use: -30 °C ~ +350 °C.
- Dissipation power factor: ≥5 mW/°C (static in the air).
- Sensor Diameter: 3 mm
- Cable Length: 1 meter
- Max power rating: 45 mW.
- The hot time constant: ≤7 s(in the air)
- Temperature coefficient of resistance : -2 ~ 5%/°C
Features/Specs:
- Temperature Measuring Range: -30 ~ 350°C
- Temperature Co-efficient: -2 ~ 5%/°C
- Hot-Time Constant: ≤7 s(in the air)
- Dissipation Power Factor: ≥5 mW/°C (static in the air)
- Max Power Output: 0.4W
- Temp Probe Cable Length: 1 Meter
- Length: 20 mm
- Sensor Diameter: 3 mm
- Weight: 6 gm
Applications:
- The temperature measurement
- Temperature compensation for transistors, ICs, and crystal oscillators in mobile communications
- Temperature sensor for rechargeable batteries
- 3D printers etc.
Package Includes:
- 1 x 100k NTC Thermistor Probe With 2 Pin JST Connector – 1 Meter Cable
Note: Product Images are shown for illustrative purposes only and may differ from the actual product.
Reviews
There are no reviews yet.