1 Channel 30A Relay Module 30A With Optocoupler Isolation 12V Supports High And Low Trigger

1 Channel 30A Relay Module 30A With Optocoupler Isolation 12V Supports High And Low Trigger

This 1 channel 12V 30A relay control board module with optocoupler modules is compliant with international safety standards, control and load areas isolation trenches it has a single relay a genuine. The inputs of the 1 Channel 12V 30A Relay Module are isolated to protect any delicate control circuitry. The power supply and relay instructions, lit, a disconnect are off. The input signal, signal, common Terminal and start conducting. It can be used as a single chip module for appliance control and work with both DC or AC signals where you can control the 220V AC load.

Note: On the high level and low level-triggered mode, If You do not understand Please Check Below Points.

• A high-level trigger refers to the signal voltage between input and trigger, which can be understood as a signal input with a VCC cathode short-circuit triggered away.
• Low-level trigger refers to the signal voltage between the input terminal and Earth OV trigger, can be understood as a signal input terminal and the GND negative electrode short circuit triggered is a way 1-channel relay module connection.

Features:

• High impedance controller pin
• Pull-down circuit for the avoidance of malfunction
• One normally closed contact and one normally open contact
• Triode drive, increasing relay coil
• Power supply indicator lamp
• Control indicator lamp
• With 4 fixed screw holes, hole diameter of 3.1mm, convenient installation, and fixation

Features/Specs:

• Operating Voltage: 11 ~ 12VDC
• No of Channel: 1
• Switching Voltage: 250VAC@30A
• Switching Voltage: 30VDC@30A
• Trigger voltage: 3 ~ 12VDC
• High impedance controller pin
• Pull-down circuit for the avoidance of malfunction
• One normally closed contact and one normally open contact
• Triode drive, increasing relay coil
• Length: 72 mm
• Width: 43 mm
• Height: 25 mm
• Weight: 30 gm

Package Include:

• 1 x 1 Channel 30A Relay Module 30A With Optocoupler Isolation 12V Supports High And Low Trigger

Note: Product Images are shown for illustrative purposes only and may differ from the actual product.