0.1-2000mhz RF Wideband Amplifier Gain 30db Low-Noise Amplifier LNA Board Module

0.1-2000mhz RF Wideband Amplifier Gain 30db Low-Noise Amplifier LNA Board Module

0.1-2000mhz RF Wideband Amplifier Gain 30db Low-Noise Amplifier LNA Board Module can be applied to various RF receive front-end and increases the communication distance. It is widely used for Short waves, FM radio, and remote control receivers, such as cable TV signal amplifiers that need low-noise RF signal amplification. Tags, Amplifier LNA Board Module, 0.1-2000mhz RF Amplifier, Low Noise Broadband Amplifier LNA Receiver Module, High Gain 30dB Low Noise Broadband Amplifier Module, WideBand Amplifier 30dB High Gain Low Noise LNA Amplifier.

Operating Tips:

1. Amplifier working frequency of the lower limit is subject to input and output capacitor, the default value is 0.1 uF, working to 0.1 MHz.
2. Increase the input and output capacitance appropriately, which can extend the cut-off frequency, such as 10uF capacitance can work to 5KHz.
3. When the power supply voltage changes in 5V-8V, it can be used as a variable gain amplifier, gain increases with the increase of the power supply voltage, which is suitable for radio frequency receive front-end circuit, using DA control power supply voltage, to control the gain of the amplifier, automatic gain control.
4. When the power supply voltage in 8V-10V, the low-frequency end gains up to 30 dB, at this time the amplifier has a low noise coefficient and good stability.
5. When the voltage is 12V, reach maximum gain, the low-frequency end gain of 32.5 dB.

Features:

• This product with wide frequency range, high gain, and low noise figure.
• This product can be applied to various RF receive front-end and increases communication distance.
• When the working frequency is less than 500 MHZ, it gets well gain flatness, which can make it less than 1dB after careful adjustment.
• The lower the frequency, the higher the gain consistency.
• Used for short wave, FM radio, remote control receivers, such as cable TV signal amplifiers need low noise RF signal amplification.

Features/Specs:

• Input supply voltage Range: 6-12VDC
• Operating frequency: 0.1-2000MHz
• Maximum power output: +10dBm at 10mW
• Amplifier gain
• F=0.1MHz, gain=32dB
• F=500Mhz, gain=31dB
• F=1000MHz, gain=29dB
• F=1500Mhz, gain=25dB
• F=2000MHz, gain=20dB
• Diameter of end Connector: 6.20mm
• System impedance: 50Ω
• Connector Gender: Both End SMA-Female
• Length: 52 mm
• Width: 25 mm
• Height: 6 mm
• Weight: 5 gm

Application:

• Vehicle monitoring, Remote control, Telemetry,
• Small wireless network, Wireless meter reading
• Access control systems, etc.

Package Includes:

• 1 x 0.1-2000mhz RF Wideband Amplifier Gain 30db Low-Noise Amplifier LNA Board Module

Note: Product Images are shown for illustrative purposes only and may differ from the actual product